This tool is very useful to check a list of Line Numbers in the PDMS/E3D. To check data consistency of a PIPE in PDMS/E3D, the following tool can be used:





In the iDEES, 'Piping Design Check' tool is a subgroup of AVEVA Utilities Form so user can select desired Lines from PDMS/E3D by using iDEES Line List and Iso Index.

This tool contains two checking tool one is Data Consistency Check and the another one is Branch Connectivity Check .


Normally for checking that all branches in the Pipes have appropriate connection references (connect to a thing), users must generate a report from 3D model contains HREF & TREF of branches and some other attribute to check the connectivity. In the tool in iDEES, is tried to show just branches that have problem in connectivity and also some branches that start or end with some component like Cap, Closure and Blind Flange have been removed automatically from this report.


The following snapshot shows main buttons in this tool :



 Data Consistency Check : This button is used to start checking of selected Lines. When user select Lines from AVEVA Utilities Form ,by this key, iDEES begins checking and after finalizing, a summarized report will be shown to user for all selected lines to show status of all lines.


 Branch Connectivity Check : This button is used to start checking of branches of selected Lines. When user select Lines from AVEVA Utilities Form ,by this key, iDEES begins checking and after finalizing, a summarized report will be shown to user for all selected lines to show status of all branches that have at least an 'Unset' Head or Tail references.


 Pipe Connectivity Check : This button is used to start checking of PIPE of selected Lines. When user select Lines from AVEVA Utilities Form ,by this key, iDEES begins checking and after finalizing, a summarized report will be shown to user for all selected lines to show status of all pipes that have at least one of the following problems:


1.Head or Tail DIRECTION NOT SAME AS Connected Pipe DIRECTION

2.Head or Tail POSITION NOT SAME AS Connected Pipe POSITION

3.Head or Tail BORE NOT SAME AS Connected Pipe BORE

4.Head or Tail CONNECTION TYPE NOT SAME AS Connected Pipe CONNECTION TYPE        


 Open Folder of Reports : This button can be used to open folder of all lines reports. iDEES generates a full report for each line and a summarized report. Both type of reports can be seen in the output folder.



Created with the Personal Edition of HelpNDoc: Full-featured EBook editor